Troubleshooting Archives | RLS Rapid Locking System

If a fitting leaks, can you just braze it in instead of cutting it out and having to add more pipe?If a fitting leaks, can you just braze it in instead of cutting it out and having to add more pipe?

Trying to braze the fitting will very likely melt the O-ring material and thus introduce contaminants into the system that could cause other system issues, so the fittings should never

What should I do if a fitting leaks after pressing?What should I do if a fitting leaks after pressing?

If the fitting was recently pressed (15-20 minutes) prior to pressurization, it is possible the bubbles are a result of trapped air in the double crimp area that can leak

What should I do to ensure that a fitting doesn’t leak after pressing?What should I do to ensure that a fitting doesn’t leak after pressing?

• Verify the tubing does not have scratches, incise marks and dents prior to tube cutting. Be careful when using a knife to cut off plastic shipping caps or insulation